Sinclair Sprockets
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Team C 01/15/2016 time 3 to 7

Go down

Team C 01/15/2016 time 3 to 7 Empty Team C 01/15/2016 time 3 to 7

Post  Muhammad Aayan Fri Jan 15, 2016 11:00 pm

Done:
• Made 2 Extra copies of the rod ends for the Intake Roller
• Sides of drive base were taken off to replace 4 6 inch wheels to 8 inch wheels(The front 2 wheels stay 2 inch!!)
• Got hubs on 2 of the new 8 inch back wheels for the belt.
• Adjusted the size of 2 of the 8 inch wheels to let the drive shaft go through

To be done:
• The new 8 inch back wheels are not able  to spin freely. The plat on the back needs to be filed or grinded about a 16th of an inch on both sides where the wheels go so they are able to spin freely. (Look at the small rough diagram on one side of the plate for better understanding)
• The hubs from the  6 inch wheels need to be taken out and replicated on to the 8 inch drive wheels.
(The drive wheels are the ones with the bigger holes in them for the shaft to go through!!!)





ALL THE WHEELS/HUBS/AND SCREWS THAT WERE TAKEN OUT AND WERNT REASSEMBLED WERE PUT IN A PLASTIC WHITE SOURCE BAG BY THE DRIVE BASE

Muhammad Aayan

Posts : 10
Join date : 2013-10-03
Age : 25

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum