Team D Friday January 22

Go down

Team D Friday January 22

Post  Bazsi Kadas on Fri Jan 22, 2016 9:44 pm

Done :

Shooter worked on
Bearings in place
Electrical pretty much done

To do:
Finish shooter
Find new hinges (current ones are really bad)

Bazsi Kadas
Bazsi Kadas

Posts : 21
Join date : 2013-09-25
Age : 19

Back to top Go down

I find Lack of detail troubling

Post  aurora on Sat Jan 23, 2016 12:10 pm

I have really no idea what was achieved in 4 hours? I have no idea what the next steps are based on the notes that were left. I spent 25to30 minutes with this team explaining what needed to be completed by the end of the shift. I want to see all persons whom were in on this shift on Monday at lunch so I can get a better understanding what happen and where we can improve for the future.


Posts : 8
Join date : 2013-09-25
Age : 19

Back to top Go down

Re: Team D Friday January 22

Post  Ben Hu on Sat Jan 23, 2016 5:21 pm

To clear any confusion:

What was done:
 - cRIo was mounted, and the piece of lexan with victors on it was put on hinges to be able to fit and allow for battery removal
 - Fixed chain for shooter A (hopefully)
 - Holes for bearings on Sam's shooter were milled (shaft with wheel will be put through)
 - Curved piece of shooter was partially re-made, and assembled
 - Shooter pieces were assembled, now only missing top pieces to help stability and prevent moving
 - Said pieces can be found along with the shooter in the black tote at the back of the class

Need to do:
 - If a coder is there, attach PWM cables to cRIO and try to get drive base running
 - Work on shooter B: Drill holes for bearings on opposing ends from previous holes, and find sprockets and chain for miniCIM and wheels to allow it to be chain driven

Ben Hu

Posts : 42
Join date : 2013-10-03
Age : 19

Back to top Go down

Re: Team D Friday January 22

Post  Sponsored content

Sponsored content

Back to top Go down

Back to top

- Similar topics

Permissions in this forum:
You cannot reply to topics in this forum