Feb 2nd 6-9
Page 1 of 1
Feb 2nd 6-9
Done
- Lathe down hex shaft but only one side
-The mounts for the window motor were adjusted to fit in the frame (Used C channel instead of angle iron for the piece that goes in between the motors because I couldn't find any long angle iron)
- Finish riveting tread onto 2 wheels
To Do
- Lathe down other side of hex shaftÂ
- Mount windows motor with bolts (It has all been clamped down)
- Finish riveting tread onto 1 more wheel
- Lathe down hex shaft but only one side
-The mounts for the window motor were adjusted to fit in the frame (Used C channel instead of angle iron for the piece that goes in between the motors because I couldn't find any long angle iron)
- Finish riveting tread onto 2 wheels
To Do
- Lathe down other side of hex shaftÂ
- Mount windows motor with bolts (It has all been clamped down)
- Finish riveting tread onto 1 more wheel
Ayman Shaikh- Posts : 18
Join date : 2013-09-26
Age : 24
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|